Timer-Controlled Recording - Teac AD-850 Mode D'emploi

6
Set the programmable timer to your desired start (power
on) and stop (power off) times.
When this setting is completed, the power to all components
should be turned off.
At this time, do not press this unit's POWER button.
Leave the button pushed in (the on position). If the
POWER button is in the off position, timer playback will
not function.
When the preset start time is reached, power will be supplied
and playback will start automatically.
< When you do not want to use the timer, set the POWER ON
START OFF-PLAY-REC (TAPE) switch to the OFF position.

Timer-Controlled Recording (

< The timer recording source can only be an external device
connected to the LINE inputs. And the timer recording can only
record to cassette tape.
(Example: Recording a broadcast program)
1
Connect this unit and a stereo system to a commercially-
available programmable timer (see page 36).
2
Set the power switches of all components to ON.
3
Prepare the cassette tape that you want to record to with
timer recording.
If the erasure prevention tabs of the cassette tape have been
broken off, put pieces of adhesive tape over the hole(s).
You can record on Normal (type ) and Chrome (type ) tapes
with this unit.
ATTENTION
Load the cassette tape with the side to be recorded facing for-
ward. Be careful not to put a tape in backward and accidentally
erase an important recording.
4
Set the POWER ON START CD-TAPE-USB switch to TAPE.
o This function cannot be used to record to USB flash drives. It
can only be used to record to cassette tapes.
5
Set the POWER ON START OFF-PLAY-REC (TAPE) switch to
the REC position.
)
"TIMER" and
o If the POWER ON START CD-TAPE-USB switch is not set to
TAPE, "INVALID" will be shown and timer recording will not be
possible.
6
Tune in the station that you want to record (when
recording from radio).
Continued on the next page
appear on this unit's display.
37