5: Setting Up The Speakers - Sony STR-SL500 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5: Setting up the speakers

You can use the SET UP menu to set the size,
distance and location of the speakers connected
to this receiver.
1
Press ?/1 to turn on the receiver.
2
Press MAIN MENU repeatedly to select
" SET UP ".
3
Press V or v repeatedly to select the
parameter you want to adjust.
For details, see "Speaker setup parameters"
below.
Note
Some speaker setup items may appear dimmed in
the display. This means that they have been
adjusted automatically due to other speaker
settings or may not be adjustable.
4
Press B or b repeatedly to select the
setting you want.
The setting is entered automatically.
5
Repeat steps 3 and 4 until you have set
all of the items that follow.
Speaker setup parameters
The initial settings are underlined.
x
S.W. XXX (SUB WOOFER)
SW
(Sub woofer selection)
• YES
If you connect a sub woofer, select "YES".
• NO
If you did not connect a sub woofer, select
"NO". The front speakers are automatically
set to "LARGE" and you cannot change this
setting. This activates the bass redirection
circuitry and outputs the LFE signals from
other speakers.
• In order to take full advantage of the Dolby
Digital bass redirection circuitry, we
recommend that you set the cut off frequency
on the sub woofer as high as possible.
x
XXXXX (FRONT)
L
R
(Front speaker size)
• LARGE
If you connect large speakers that will
effectively reproduce bass frequencies, select
"LARGE". Normally, select "LARGE".
• SMALL
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select "SMALL" to activate
the bass redirection circuitry and output the
front channel bass frequencies from the sub
woofer. When the front speakers are set to
"SMALL", the center and surround speakers
are also automatically set to "SMALL"
(unless previously set to "NO").
x
XXXXX (CENTER)
C
(Center speaker size)
• LARGE
If you connect a large speaker that will
effectively reproduce bass frequencies, select
"LARGE". Normally, select "LARGE".
However, if the front speakers are set to
"SMALL", you cannot set the center speaker
to "LARGE".
• SMALL
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select "SMALL" to activate
the bass redirection circuitry and output the
center channel bass frequencies from the front
speakers (if set to "LARGE") or sub woofer.
• NO
If you did not connect a center speaker, select
"NO". The sound of the center channel will be
output from the front speakers.
a)
b)
continued
13
GB

Publicité

Table des Matières
loading

Table des Matières