KitchenAid KURO24RSBX Guide D'utilisation Et D'entretien page 7

Attach the Overlay Panel
NOTE: If the overlay hooks are not installed, see "Custom Overlay
Panel" for overlay hook locations.
1. Position the overlay panel ¹⁄₂" (1.27 cm) higher than the door.
Be sure to position the overlay hooks to the pilot holes.
2. Insert the overlay hooks into the top of the holes in the door.
Push against the overlay panel to force the overlay hooks
deeper into the door. Pull the overlay panel straight down to
secure the overlay hooks to the door.
3. Using a Phillips screwdriver, attach the overlay plates to the
bottom of the overlay panel and door as shown.
A B
A. Overlay panel
B. Door
C. Overlay plates (2)
D. Round-head screws (8)
Install the Door
IMPORTANT: To ensure proper operation, be sure to grease the
top hinge, top spacer and washer with petroleum jelly.
1. Using a Phillips screwdriver and three screws, attach the top
spacer to the door.
2. Using petroleum jelly, grease the bottom spacer hole and the
bottom hinge pin. Align the washer with the bottom spacer
hole.
3. Install the door by inserting the bottom hinge pin into the
bottom spacer hole. Be sure the washer remains in place.
Slowly lower the door straight and evenly onto the bottom
hinge pin. Close the door. Be sure the door properly aligns to
the cabinet.
NOTE: Provide additional support for the door when moving
the hinges. Do not depend on the door magnets to hold the
door in place while you are working.
C D
4. Using masking tape, secure the door to the cabinet before
installing the top spacer as shown.
A. Top spacer
B. Masking tape
5. Place the washer on the top spacer and align the holes.
Grease the top hinge pin, top spacer and washer with
petroleum jelly. Insert the top hinge pin into the washer and
top spacer.
6. Using a Phillips screwdriver and three screws, attach the top
hinge to the cabinet as shown.
A. Screws (3)
B. Top Hinge
C. Washer
7. Remove the masking tape from the door.
A
B
A
B
C
D
E
F
D. Top spacer
E. Door
F. Overlay panel
7