Philips GC4800 Série Mode D'emploi page 19

Problem Possible cause
The iron is There is a connection
plugged in, but problem.
the soleplate
is cold.
The temperature dial
is set to MIN.
The iron does There is not enough
not produce water in the water
any steam. tank.
The steam control is
set to position 0.
Guarantee and service
If you need information or if you have a
problem, please visit the Philips website at
www.philips.com or contact the Philips
Consumer Care Centre in your country (you find its
phone number in the worldwide guarantee leaflet). If
there is no Consumer Care Centre in your country,
go to your local Philips dealer.
troubleshooting
If the appliance does not work or does not work
properly, first check the list below. If the problem
is not mentioned in this list, the appliance probably
has a defect. In that case we advise you to take the
appliance to your dealer or to an authorised Philips
service centre.
Solution
Check the mains cord, the plug and
the wall socket.
Set the temperature dial to the
required position.
Fill the water tank (see chapter
'Preparing for use', section 'Filling the
water tank').
Set the steam control to a position
between 1 and 6 (see chapter 'Using
the appliance', section 'Steam ironing').
EnGlish
19