Removing The Bath Lift - Invacare Aquatec R Manuel D'utilisation

IMPORTANT!
Risk of damage
Damage to the product caused by the spindle foot
slipping out.
– Ensure that the spindle foot is fully retracted,
before folding up the backrest.
– Once the backrest is folded up, ensure that the
spindle foot is in the spindle foot retainer.
4. Hold the backrest at the center of the head end and carefully lift
it into the end position.
C
Plug the jack socket with the unlocking sleeve C on the spiral
5.
cable B of the hand control A to the jack plug D until the
locking mechanism engages noticeably.

4.3 Removing the bath lift

1. Let the water out of the bathtub.
2. Lower the bath lift using the Down button until the backrest
stops in the lowered end position, ® 5.2 Controlling the bath
lift, page 13.
1471194-A
A
B
D
3. Unlock the jack socket on the spiral cable of the hand control by
pushing up the unlocking sleeve and pull it off the jack plug.
IMPORTANT!
Risk of damage
– When folding the backrest down, ensure that
spiral cable of the hand control does not become
trapped.
– Do not fold the backrest down if there is water
in the bathtub.
B
C
4. Hold the backrest at the head end with one hand and fold it
forwards to the end position A.
5. Pull the backrest up off the seat and out of the bathtub B.
6. Fold the side flaps of the seat inwards C.
IMPORTANT!
– Release both rear suction cups simultaneously.
A
Setup
11