Technical Data - Jonsered CS2258 Li Manuel D'utilisation

LED screen
LED 4 is green
LED 1 is red and LED 2 is
green, battery pack does not
charge or operate correctly in
product
RED LED comes on, LED 2
is green and flashes during
charging or when the battery
pack is in the battery charger
RED LED flashes and LED 2
flashes green when the bat-
tery pack is installed.
Motor specifications
Motor type
Motor voltage
Motor power
Battery and charger specifications
Default battery pack type
Default battery charger type
Noise and vibration data
Equivalent vibration level (ahv, eq) left handle
Equivalent vibration level (ahv, eq) right handle
1
Equivalent vibration level is calculated as the time-weighted energy total for vibration levels under various
working conditions. Reported data for equivalent vibration level has a typical statistical dispersion (standard
deviation) of 1.5 m/s
2
Equivalent vibration level is calculated as the time-weighted energy total for vibration levels under various
working conditions. Reported data for equivalent vibration level has a typical statistical dispersion (standard
deviation) of 1.5 m/s
666 - 006 - 03.06.2019
Possible faults
Battery pack is
overcharged
Battery pack failure Remove battery pack from the product. Do not charge. Battery
Internal battery
tempature is too
low or too high for
charging
Internal battery
temperature is too
low or too high

Technical data

1
2
2
.
2
.
Possible steps
Remove the battery pack from the battery charger and install in
the product. Operate the product. Battery charger may be de-
fective. Speak to an approved service center.
pack is damaged and must be replaced. Speak to an approved
service center.
Move the battery charger and battery pack to a location where
the internal temperature of the battery pack can be between
5°C (41°F) and 45°C (113°F).
The internal temperature in the battery must be between -15°C
(5°F) and 70°C (158°F). The environment temperature in the
battery pack is too low or too high.
• If the battery pack is too cold from the ambient environ-
ment, move the battery pack and battery charger to a warm
environment.
• If the battery pack is too hot, especially after operation,
move the battery pack and battery charger away from the
hot environment.
unit CS2258 Li
(BCS58VJN)
Brushless
V (DC) 58
W 2000
280Li
440Ci
2
m/s 1.430
2
m/s 2.277
19