Technical Data; Cs 2186 - Jonsered CS 2186 Manuel D'utilisation

Engine
3
Cylinder volume, cu.in/cm
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Power, kW/ rpm
Ignition system
Manufacture
Type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Manufacturer
Carburetor type
Fuel capacity, US pint/litre
Oil pump capacity at 8500 rpm,
ml/min
Oil capacity, US pint/litre
Type of oil pump
Weight
Without bar and chain, Lbs/kg
Chain/bar
Standard bar length, inches/cm
Recommended bar lengths,
inches/cm
Usable cutting length, inches/cm
Chain speed at max. power, m/sec
Pitch, inch/mm
Thickness of drive link, inch/mm
Number of teeth on drive sprocket
34
– English

TECHNICAL DATA

CS 2186

5,2/84,7
2,1/54
1,5/37
2 700
4,6/ 9 600
SEM
CD
Champion RCJ 7Y
NGK BPMR 7A
0,02/0,5
Tillotson
HS296A
1,6/0,9
4-20
0,9/0,5
Automatic
15,6/7,1
XPG: 16,1/7,3
18"/46
16-32"/40-80
15-31"/38-78
21,4
3/8"/9,52
0,050"/1,3
0,058"/1,5
0,063"/1,6
7
RECOMMENDED CUTTING EQUIPMENT
FOR CANADA
The following is a list of recommended cutting equipment
for Class 1A and 1B Chainsaws.
The combinations of powerhead, bar and chain meet all
requirements outlined in the CSA Z62.1-95 Chainsaws and
Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you
may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose
guide bars of the same pitch and having the same number
of sprocket teeth may be considered to have equivalent
kickback energy.
A hard nose bar having the same length and nose radius
as a sprocket-nose bar may be considered to have
equivalent or less kickback energy than the sprocket-nose
bar.
We recommend that you as replacement use the listed bars
and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Guide bar
Length Pitch Max nose
inch inch radius
16-32 3/8" 11T
Note: For the chains above you are free to choose between
0,050", 0,058" and 0,063" gauge drive link for the corresponding
bar, see the table below.
0,050"/1,3 mm – 72LP
0,058"/1,5 mm S42 73LP
0,063"/1,6 mm – 75LP
WARNING! These models of chain saws are
capable of severe kickback that could result in
serious injuries to the user. Do not operate these
saws unless you have extraordinary cutting needs
and experience and specialized training for dealing
with kickback. Saws with significantly reduced
kickback potential are available. Always use the
safest saw and cutting equipment applicable to
your cutting need.
Saw chain
Jonsered S42 or
Oregon 73LP / 73LG or
Sabre 988PC
72LG 980PC
73LG 988PC
75LG 983PC