Charge Status; Pulse Charging; Appliance Protection Function; Overheating Protection - Bosch C7 Notice D'utilisation

english | 22

Charge status

The charge status of the connected battery is
indicated as follows on the charger.
8
= Trickle charging
OK
Mode
75 %
Red
Yellow
Green

Pulse charging

This is an automatic charger function which
cannot be selected manually. If the battery voltage
at the start of charging is between 7.5 V (± 0.5 V)
and 10.5 V (± 0.5 V) in 12 V mode and between
16 V (± 0.5 V) and 21 V (± 1.0 V) in 24 V mode, the
charger switches automatically to pulse charging.
On attaining a battery voltage above 10.5 (± 0.5 V)/
21 V (± 1.0 V), the charger switches automatically
to the charging mode previously selected. This
enhances the charging process.
Automotive Aftermarket

Appliance protection function

The charger switches to standby mode in the follow-
ing abnormal situations.
3 Regeneration process > 7 hours
3 Charging > 41 hours
3 Battery voltage < 7.5 V (12 V batteries)
3 Battery voltage < 16 V (24 V batteries)
25 %
3 Open circuit
3 Reverse polarity
In the event of reverse polarity, the LED (9)
will also light up. If no other setting is made,
the system remains in standby mode.
50 %
In the event of a short circuit at the charging cable,
fuse (4a) prevents damage to the device and the
electrical system. Check fuse (4a) if Mode selection
is not possible.

Overheating protection

If the unit becomes excessively hot during charging,
the output power is automatically reduced to avoid
damaging the unit.
Battery charger | C7 | 12.2011