Adjusting The Sound Characteristics; Changing The Sound And Display Settings - Sony XR-C900RDS Mode D'emploi

If you need to mount the rotary remote on the
right of the steering column, you can reverse
the operative direction of the controls.
Press (DSPL) two seconds while pushing
the VOL control.
Tip
You can control the operative direction of controls with the
unit.
Adjusting the sound
characteristics
You can adjust the sub output volume, bass,
treble, balance and fader.
Each source can store the sub output, bass and
treble level respectively.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n SUB (sub output volume)
n BAS (bass) n TRE (treble) n BAL
(balance) n FAD (fader)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting.
(After three seconds, the dial works as
volume control dial.)
Changing the sound and
display settings
You can set:
•Amber/Green to change the illumination
colour to amber or green.
•Beep to turn on or off the beeps.
•Dimmer to change the brightness of the
display.
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
•Loud (Loudness) to enjoy bass and treble
even at low volume. Bass and treble will be
reinforced.
•RM (Rotary Remote) to change the operative
direction of the controls of the rotary remote.
— Select "norm" to use the rotary remote as
the factory preset position.
— Select "rev" when you mount the rotary
remote on the right of the steering column.
•Angle to change the angle of the front panel.
— Select "1" to make the front panel angle at
about 80 degrees.
— Select "2" to make the front panel angle at
about 70 degrees.
•Contrast to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
1
Press (SHIFT), then press (2) (SET UP).
2
Press (2) (SET UP) repeatedly until the
desired setting mode appears.
Each time you press (2) (SET UP), the item
changes as follows:
Clock n Amber/Green n Beep n Dimmer n
CT n Loud* n RM n Angle n Contrast
* When you tune in the station or listen to the tape
(CD/MD), "Loud" appears.
3
Press (4) (n) to select the desired
setting (for example: "on" or "off").
At "Contrast" setting, pressing (4) (n)
makes the contrast higher, and pressing (1)
(N) makes the contrast lower.
4
Press (SHIFT).
When the mode setting is complete, the
normal playback mode appears.
EN
15