Helpful Hints - Dremel WorkStation 220 Instructions D'utilisation

9. The Angle Lock Levers are used to secure
the tool either vertically or at a 90° angle.
Tool may be used at a 15°, 30°, 45°, 60°,
75° or 90° angle for sanding, polishing,
grinding or brushing application (figure G).
Loosen the large and small levers and ro-
tate the tool, then securely tighten both
angle lock levers (figure C and D).
10. The Height Adjustment Lever is used to se-
cure the press on the tube at the proper
height.
Loosen the lever and move the press/tool
assembly to the desired position, then tight-
en the height adjustment lever (figure D).
11. Mark the hole locations on the workpiece
and center punch at these locations. Cen-
When drilling round pieces, use a "V" block or
vise. To drill a hole in the center of a round
piece, a center punch mark is necessary (fig-
ure I). Use center punch to make center punch
mark (not included).
Making optional hold down clamps
Hold down clamps can be fabricated out of
wood, steel or aluminum, depending on your
application (figure J).
1. Cut or saw material to desired length, width
and height.
2. Drill a hole using a 8 mm drill bit in the
desired location, through the clamp and
spacer.
3. Mount the hold down clamps using a
8 mm - 40 mm or 50 mm length carriage
bolts with matching washers and wing nuts.
In case of a complaint, send the tool undisman-
tled together with proof of purchase to your
GB
Operation (continued)

Helpful hints

for your workstation 220
Service
ter punching will prevent walking of the drill
point and ensure proper hole location.
12. Secure the workpiece to the base before
drilling. This will keep the workpiece from
climbing the drill bit or spinning. The bene-
fit is safety and better quality work. Hold
downs clamps (not included) are very good
for holding workpiece, or use a small utility
vise for holding when drilling (figure H).
13. Loosen the Height Adjustment Lock Knob
1/2 turn and move the press on the tube
until drill bit tip is near the workpiece (fig-
ure F). A maximum of 6 mm between drill
bit tip and workpiece is recommended.
Retighten lock knob.
14. Grasp the Press Handle and pull down to
drill hole.
Avoid force feeding to such an extent that the
motor speed is noticeably reduced. Also, feed
carefully when approaching point of break-
through. This will avoid making ragged break-
through edges.
4. Mount to base by sliding the head of the
carriage bolt up through the bottom of the
base with the wing nuts on top.
When using hold down clamps on workpieces
larger than 6 mm in thickness, always use a
spacer block to support the back side of the
clamp. For the best support, the spacer block
should be cut about 3 mm shorter in height
than the workpiece.
dealer or to the nearest Dremel service station
(addresses are listed on www.dremel.com).
5