Power Tool Safety Rules - Dremel WorkStation 220 Instructions D'utilisation

WARNING
!
may result in electric shock, fire and/or serious personal injury.
Safety Rules for WORKSTATION
Unplug tool before setting up in table, mak-
ing adjustments or changing bits.
Securely fasten WORKSTATION to a stable
table or platform before operating.
Know how to shut off the tool! Position the
tool so that switch is readily accessible to
quickly shut off in an emergency.
Route the cord away from the bit or cutting
area. Cutting into live electrical wires may re-
sult in a shock, burn or electrocution.
Wear eye, ear protection and dust
mask. Using personal safety devices
and working in safe environment re-
duces risk of injury.
Do not wear gloves or loose clothing during
operation of the tool.
Match the appropriate bit and its speed to
your application. Do not use bits that have a
cutting diameter that exceed the capacity
of the tool. The drill press stand is intended
primarily for light duty use on wood, plastic
and metal. Overloading the tool can lead to
personal injury or tool failure.
Never use dull or damaged bits. Sharp bits
must be handled with care.
Always make sure the workpiece is free
from nails and other foreign objects.
Before operation clamp workpiece or brace
against column. Never hold a small work-
piece in one hand and bring the drill down.
Clamping the workpiece allows you to use
both hands to control the tool.
Use a "V" block for supporting round stock
such as tubes or rods when drilling. Round
material such as dowel rods, pipes or tubing
have a tendency to roll while being cut, and
may cause the bit to "bite" or the workpiece to
jump toward you.

Power Tool Safety Rules

Read and understand all instructions (including instructions of the
tool that is used with the attachment). Failure to follow all instructions
SAVE THESE INSTRUCTIONS
GB
You must set and lock tool head into the
desired position and depth of cut when
performing operations other than drilling.
Bring the workpiece to the tool and allow
for sufficient space between your hand and
the spinning bit.
This Drill Press was designed for drilling, sand-
ing, brushing, polishing or grinding applica-
tions, other applications may present hazards
that cannot be adequately guarded.
If the side of any rotating accessory is used to
perform the work, for example a sanding
drum, the workpiece must be positioned on
the side of the accessory that rotates against
the feed direction of the workpiece. Placing
the workpiece on the side of the accessory
where the feed direction and accessory rota-
tion are same may cause the workpiece to be
pulled by the rotating accessory and lead to
loss of control during operation.
Never start the tool when the bit is engaged
in the material.
Do not reach in the area of the spinning bit.
The proximity of the spinning bit to your hand
may not always be obvious. Workpiece could
shift or your hand could slip during operation.
Wear a dust protection mask when working
with materials wich produce dust thats is
detrimental to health; inform yourself be-
forehand about the materials to be worked on.
After changing the bits or making any adjust-
ments, make sure the collet nut and any other
adjustment devices are securely tightened.
Never touch the bit during or immediately
after the use. Contact with a spinning bit will
cause injury and after use the bit is too hot to
be touched by bare hands.
Do not leave a running tooling unattended,
turn power off. Only when tool comes to a
complete stop it is safe to remove workpiece
and clean the stand.
3