Schluter Systems LIPROTEC LT EBR 1 Notice D'utilisation page 68

Fault Cause of
fault
The receiver
has been
modified
The receiver
has been
positioned
too low.
No The
connection Bluetooth
to the receiver is
mobile too far away
device. from the
end device.
Sources of
disturbance
in the
reception
area
The end
device is not
paired with
the
Bluetooth
receiver.
Bluetooth receiver directions for use
Elimination of faults
Troubleshooting
For modifying the receiver, use
materials permissible for radio
communication.
The receiver must be positioned
higher.
The Bluetooth connection has a
maximum range of 10 m.
Change the positioning of the
receiver and if necessary
eliminate the source of
disturbance.
Pair the end device with the
receiver (see chapter "Setup").
EN
65