Schluter Systems LIPROTEC LT EBR 1 Notice D'utilisation page 66

Fault Cause of
fault
No lighting Connections
mixed up
No voltage
present
Receiver
overloaded
Power pack
overloaded
Lighting Cable
flashes or connections
flickers are not
firmly
tightened
Receiver
overloaded
Bluetooth receiver directions for use
Elimination of faults
Troubleshooting
Check that all of the cable
connections are connected
properly
Check that the power pack is
connected properly
Check the maximum load of the
respective connections on the
receiver. The LED strips may
have to be distributed differently
over the respective connections
(observe the respective
connections' maximum load).
Select a larger power pack (up
to max. 200 W)
Check the cable connections for
non-positive locking.
Check the maximum load of the
respective connections on the
receiver. The LED strips may
have to be distributed differently
over the respective connections
(observe the respective
connections' maximum load).
EN
63