Schluter Systems LIPROTEC LT EBR 1 Notice D'utilisation page 55

EN
Mounting
To mount the wall bracket for the remote control using
adhesive strips, proceed as follows:
Ensure that the selected wall bracket mounting position

is clean, free of separating agents and smooth, to ensure
that the entire surface of the adhesive strips can be
affixed.
Pull off the protective film from one side of the adhesive

strip and stick it without any folds to the back of the wall
bracket.
Pull off the protective film from the other side of the

adhesive strip and press the wall bracket for several
seconds onto the selected mounting position with the
"top" sticker at the top.
You can now remove the sticker and store the

remote control in the wall bracket.
To mount the wall bracket for the remote control using
screws, proceed as follows:
Make sure that the selected mounting position is flat, so

the wall bracket does not get twisted when tightening the
fixing screws. Also make sure that the subsurface is
suitable for drilling holes to a depth of 40 mm.
Mark two points at a distance of 84 mm above one

another at the desired position.
Drill one 40 mm hole using a 5 mm at each point.

Press the two dowels provided (see fig. A, item 4) into

the holes.
52 Bluetooth receiver directions for use