Position Bluetooth Receiver - Schluter Systems LIPROTEC LT EBR 1 Notice D'utilisation

Secure the wall bracket (see fig. A, item 2) on the wall

using the two cross-recess screws provided (see fig. A,
item 3) with the "top" sticker at the top.
Tighten the two cross-recess screws by hand.

You can now remove the sticker and store the

remote control in the wall bracket.

5.2 Position Bluetooth receiver

You can position the Bluetooth receiver in an installation box
or behind the panelling between the power pack and LED
strips.
Observe the following points when positioning the Bluetooth
receiver to obtain good reception and the greatest possible
level of operating safety:
Make sure that the maximum permissible lengths of the

connection cable are not exceeded:
– The length of the connection cable to the power
pack may not exceed 2 m. Connect the Bluetooth
receiver directly to the power pack if possible.
– The length of the connection cable to the installation
box, into which the connections of several LED
strips are combined, may not exceed 10 m.
– The length of the connection cable to a directly
connected LED strips may not exceed 3 m.
Bluetooth receiver directions for use
EN
Mounting
53