Testing Remote Control; Test Bluetooth Connection - Schluter Systems LIPROTEC LT EBR 1 Notice D'utilisation

EN
Commissioning

7.2 Testing remote control

The Bluetooth receiver and the remote control
provided are already connected in their delivery
state.
You can immediately retrieve the
manufacturer's default settings of the Bluetooth
receiver for brightness, colour, colour
temperature or colour gradient using the remote
control.
In order to test the functionality of the remote control, proceed
as follows:
Press the "on/off" button on the remote control (see fig.

C, item 2)
This should switch the entire LIPROTEC system

"on/off".
Press the arrow keys (see fig. C, items 3 and 4) several

times.
This should retrieve the default settings of the

Bluetooth receiver.
If the system does not function flawlessly, continue

reading in the faults chapter.

7.3 Test Bluetooth connection

To test the Bluetooth connection, proceed as follows:
Use the remote control to initiate the connection

establishment between the mobile device and the
Bluetooth receiver.
58 Bluetooth receiver directions for use