Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
14. Keep motor air vent clean.
The tool's motor air vent must be kept clean so that air can freely flow at all times. Check
for dust build-up frequently.
15. NEVER use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.
16. NEVER leave tool running unattended. Turn power off.
Don't leave tool until it comes to a complete stop.
17. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.
18. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
19. ALWAYS wear eye protection that meets the requirement of the latest revision of ANSI
20. Definitions for symbols used on this tool
V ... volts
--- .. direct current
n
... no load speed
o
---/min .... revolutions or reciprocation per minute
Standard Z87.1.
English
7
Publicité
Table des Matières
