Technical Data; Transport And Installation - Abicor Binzel xFUME FLEX Mode D'emploi

5 Transport and installation

4.2 Technical data

Tab. 1
Connection voltage
Line frequency
Rated current
Drive power
Primary filter surface area
Pre-filter surface area
Air inlet
Air outlet
Max. air volume flow
Sound pressure level LpA
Weight of device incl. extraction arm
Dimensions (L × W × H)
Length of extraction arm
Tab. 2
Ambient temperature
(operation, storage in a closed
environment)
Ambient temperature (transport)
Relative humidity
5 Transport and installation
Risk of injury due to improper transport and installation
Improper transport and installation can cause the device to tip or fall over. This may result in serious
injuries.
► Check and wear your personal protective equipment.
► Ensure that all supply lines and cables do not encroach into the area in which employees are working.
► Place the device on a suitable base (flat, solid, dry) on which it will not topple over.
► Note the weight of the device when lifting it.
 4.2 Technical data on page EN-10
► Use an appropriate lifting tool with load handling attachment for transporting and installing the
device.
► Transport the device only by the handle.
► Avoid abrupt lifting and setting down.
► Do not lift the device over persons or other devices.
Risk of injury due to moving extraction arm
If the extraction arm is protruding when the device is moved, it could cause injury to people standing
nearby.
► The device should be moved only when the extraction arm is upright.
EN - 10
General information
Ambient conditions for transport, storage and operation
WARNING
CAUTION
xFUME™ FLEX
xFUME™ FLEX 115V CSA
115 V
60 Hz, 1.1 kW
15 A
1.1 kW
36 m²
0.43 m²
Ø = 170 mm
310 × 142 mm
1200 m³/h
≤ 72 dB (A)
120–129 kg
700 mm × 700 mm × 1095 mm
2000, 3000 or 4000 mm
xFUME™ FLEX 115V CSA
0 °C to +40 °C
-15 °C to +40 °C
Up to 90% at +20 °C