Checking For Correct Assembly; Emergency Manoeuvres, Maintenance Or Cleaning; Troubleshooting; Environmental Protection - GIESSE VARIA SLIM BASE Manuel D'utilisation Et D'installation

11. CHECKING FOR CORRECT ASSEMBLY

Check that the window is perfectly closed at corners and that there are no obstacles
caused by incorrect positioning during assembly.
Check that when the window frame is closed the chain terminal is at least a few millimetres
away from the actuator body. This will ensure the window is properly closed and seals are
correctly compressed. In the event that this should not be the case there is no guarantee
that the window is closed correctly.
Check that hinges and support brackets are aligned to each other and tightly fixed against
the window frame with screws fixed correctly into position.
Check that the window reaches the desired position according to the stroke-end selected.

12. EMERGENCY MANOEUVRES, MAINTENANCE OR CLEANING

In the event that the window frame should require manual opening due to power failure or problem with
the mechanism or for normal maintenance or external cleaning of the window frame, the patent allows
rapid unhooking of the chain. To perform this operation, proceed as follows:
1. Unhook the flap of the quick hook locking the chain terminal to the bracket.
2. Hold the window in one hand and remove the pin of the chain terminal from the two u channels
on the bracket with the other. (This operation should be performed with the
window open at least 10 cm to facilitate unhooking of the chain).
3. Manually open the window frame.
A
TTENTION
longer held in position by the chain.
4. After maintenance and/or cleaning repeat points 1 and 2 in reverse order.

13. TROUBLESHOOTING

Possible causes of malfunction during installation or use.
Problem
Actuator does not work

14. ENVIRONMENTAL PROTECTION

All materials used in the manufacture of this appliance are recyclable.
We recommend that the device itself, and any accessories, packaging, etc. be sent to a centre
for ecological recycling as established from laws in force on recycling.
The device is mainly made from the following materials: aluminium, zinc, iron, plastic of various
type, cuprum. Dispose materials in conformity with local regulations about removal.
–
: the window could fall as the sash is no
DANGER
Possible cause
▪ No electricity at feeder
▪ Cable not connected or wire
disconnected.
32
Solution
▪ Check status of circuit breaker
or safety switch
▪ Check electrical connections
at reduction motor