Eu Declaration Of Incorporation - GIESSE VARIA SLIM BASE Manuel D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
17. EU DECLARATION OF
(Annex IIB DIR. 2006/42/EC)
The Company
in its capacity as MANUFACTURER
AUTHORIZES PREPARATION OF THE PERTINENT TECHNICAL DOCUMENTATION BY
Mr Matteo Fini Via Tubertini 1
40054 Budrio (Bologna) - ITALY
AND DECLARES HEREWITH THAT THE PARTLY COMPLETED MACHINE
Designation: VARIA SLIM BASE
Model: VARIA SLIM BASE 24V, VARIA SLIM BASE 230V
Intended use: Electromechanical actuator with chain for automation of bottom-hung and top-hung windows,
pivoting windows, skylights and other casement types.
Serial data and year of construction shown on the product nameplate.
COMPLIES WITH AND IMPLEMENTS THE FOLLOWING ESSENTIAL REQUIREMENTS OF DIRECTIVE
2006/42/EC:
-
E.S.R. from 1.1.1 to 1.1.3
-
E.S.R. 1.1.5
-
E.S.R. from 1.3.2 to 1.3.4
-
E.S.R. from 1.3.7 to 1.3.8.2
-
E.S.R. from 1.4.1 to 1.4.2.1
-
E.S.R. from 1.5.1 to 1.5.2
-
E.S.R. from 1.5.4 to 1.5.6
Observance of harmonized standards:
-
UNI EN ISO 12100 (2010)
-
CEI EN 60204-1 (2006)
THE PERTINENT TECHNICAL DOCUMENTATION HAS BEEN DRAWN UP IN COMPLIANCE
WITH SECTION B OF ANNEX VII
This partly completed machine must not be put into service until the final machinery into which it is to
be incorporated has been declared in conformity, where appropriate, with the provisions of Machinery
Directive 2006/42/EC (the CE mark required under this same directive is consequently not affixed).
This Declaration of incorporation is issued under the sole responsibility of the manufacturer.
The manufacturer undertakes, in response to a reasoned request by the national authorities, to transmit relevant
information on the partly completed machinery; such an undertaking includes the methods of transmission and
shall be without prejudice to intellectual property rights owned by the manufacturer of the partly completed
machinery.
Budrio, dated 26 April 2018
INCORPORATION
Via Tubertini, 1 40054 Budrio (BO) - Italy
Tel +39 051 8850000 - Fax +39 051 8850001
www.giesse.it - infotechgiesse@schlegel.com
35
GIESSE S.p.A
-
E.S.R. 1.5.8
-
E.S.R. 1.5.11
-
E.S.R. 1.6.1
-
E.S.R. from 1.6.3 to 1.6.4
-
E.S.R. from 1.7.1 to 1.7.2
-
E.S.R. 1.7.4
The officer Peter Santo,
Legal Representative, GIESSE S.p.A

Publicité

Table des Matières
loading

Table des Matières