GIESSE VARIA SLIM BASE Manuel D'utilisation Et D'installation page 29

Figure 4
Above the drawing of specific application using accessories provided. For different mountings,
please contact manufacturer.
A. Trace centrepoint X in pencil onto the window frame (Fig.2).
B. Use brackets "A" and hinge "D" (provided) (Fig.3).
C. Apply the template onto the window frame (fixed part), taking care to ensure that the axis of the
template coincides with centrepoint X traced earlier (Fig.4). Attention: for non coplanar window
frames, cut the grey part of the template along the red line and apply onto the mobile part of the
window frame, taking care to keep it in the same reference position for the X axis.
D. Bore the window frame at the points indicated on the template (Fig.5).
E. Apply the brackets (A) to the window frame using flat head screws as indicated above. Check both
horizontal and vertical alignment of brackets.
F. Assemble the hinge for top hung windows (D) onto the mobile part of the window frame using the
reference points indicated on the template.
G. Complete assembly between chain terminal and quick hook using the Ø4x32 pin provided and insert
into central position (Fig.6).
H. Hook the actuator onto the brackets inserting the two channels at the end of the actuator into the
pins provided.
I. Rotate the actuator 90°, bring the chain terminal up to the hinge and insert the pin into the channel
of the latter. Connect the quick hook onto the bracket. At initial connection the hook will present
some resistance, this is normal as pieces need to adjust to their sockets.
J. Perform the electrical connections according to the diagram below or the label on the feeder cable.
K. Check that the output of the chain is perfectly aligned with the bracket. In the event that this should
not be the case, loosen the fixing screws and reposition the bracket correctly.
L. Perform a complete test of opening and closing of the window frame. After closure, check that the
window frame is completely closed and check pressure against the seals.
M. The stroke-end of the actuator during return is automatic. The appliance exerts traction of over
280N to guarantee perfect pressure against the seals.
8.3. Assembly for bottom hung windows
–
Inward application
window
Figure 9
transom
Figure 5
Figure 7
Figure 10
29
Figure 6
Figure 8
Figure 11