Quick EAGLE E 712 D Manuel De L'utilisateur page 11

BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING: the Quick
poses. Quick ® shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty
use of the equipment.
(storms). Always deactivate the windlass when not in use.
Check that there are no swimmers nearby before dropping anchor.
For improved safety we recommend installing at least two anchor windlass controls in case one is accidentally
damaged. We recommend the use of the Quick
Secure the chain with a further device before starting the navigation.
The solenoid unit or reversing solenoid unit must be installed in a point protected from accidental water contact.
THE PACKAGE CONTAINS:
manual - warranty card.
TOOLS REQUIRED FOR INSTALLATION:
hexagonal wrenche: 13 mm.
®
"QUICK "ACCESSORIES RECOMMENDED:
HRC1002) - Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC1102M and CH-
C1202M) - Radio control (mod. 1302,1352; 02, 302).
INSTALLATION REQUIREMENTS:
the upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appropri-
ately (a lack of parallelism could result in a loss of motor power). The deck thickness must be included among the figures listed
in the table. In cases of other thicknesses it is necessary to consult a Quick
the passage of cables and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE:
Remove excess material from the chain through hole, ensuring the free passage of the chain. Position the windlass lowering it
from above deck and inserting the gasket between the deck and the base. Screw the stud bolts, using the short threaded end,
onto the base. Apply a medium grade locking product onto the thread. Fix the windlass with the screws provided onto the fix-
ing studs. Connect the supply cables from the windlass to the solenoids.
WARNING:
before wiring up, be sure the electrical cables are not live.
EAGLE 700/1000/1400W - REV005A
® windlasses are designed to weigh the anchor.
The windlass is not designed for the loads that might occur in extreme weather conditions
windlass - solenoids unit - base gasket - handle - bolts and screws (for assembly) - user's
drill and drill bits: Ø 9 mm (23/64") - Ø 51 mm (2") and Ø 127 (5") hollow mill;
anchoring RL control board (mod. 800) - Waterproof hand helds R/C (mod.
the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that
max 5 mm
(3/16")
when the ideal position has been established, drill four holes using the drilling template provided.
45°
INSTALLATION
® " DEALER
.
Do not use the equipment for other pur-
® hydraulic-magnetic switch as the motor safety switch.
® retailer. There must be no obstacles under deck to
40 cm
(16")
GB
11