General Notes; Setting Up Block Assemblies Using The Modular Pneumatic - Burkert 6510 Instructions De Service

INSTALLATION, INITIALISATION AND SERVICE

General Notes

Work on the valve should only be carried out by specialist staff and with the correct tools!
Before working on the system, always turn off the supply voltage!
Clean the piping system before installing the valve!
Where necessary, connect a strainer upstream to protect against faults.
When tightening the connections, never use the coil as a lever!
Ensure that the operational conditions agree with the performance data of the unit! Avoid
back-pressures in the exhaust channels by the use of large-volume silencers!
ATTENTION!
Lines or valves must never be loosened while the system is under pressure!
Manual override:
To operate the valve manually, turn the manual override by 90° in the direction of the arrow.
Setting up block assemblies using the modular pneumatic rails
Type MP01 or MP02
With combination of two-way, three-way and twelve-way base modules, you can assemble valve blocks
of any size.
NOTE It is advisable to start the assembly with the left-most connector module. (Fig. 1).
Check that each module is completely pre-fitted with O-rings!
Before locking together, lightly grease or oil the fitted O-rings.
Latch the hooks of the module being added into the latching slot on the previous
module, ensuring that the O-rings are correctly seated!
Press the modules together until both hooks latch.
Lay the flat gaskets into the centering pins on the base module, ensuring that the
seals are correctly seated.
ATTENTION!
Secure the valves to the base module using 2 screws each.
(Tightening the screws to 30 Ncm crosswise).
Mount the complete valve block onto the wall or the standard rail.
Connect the supply and working lines.
Make the electrical connections to the pilot valves: in doing this, observe the values given on the rating
plate!
12 - 6510/6511
Squashed O-rings and flat gaskets sause leackages in the block!