ADURO H2 Mode D'emploi page 61

3.3.4 Lighting the fire with pellets
Push the ON/OFF button and wait until the ON button displays a constant green colour. The lighting of the
fire will then start automatically and the pellet burner will start. When the stove is lighting, the combustion
chamber will be filled with smoke until the ignition starts. After approx. 6 minutes flames should appear.
Normal use should be achieved after 15-20 minutes.
When the smoke temperature reaches 90 degrees, the stove will shift from the "warm up mode" to "normal
mode" and continue with the last settings. You can manually change between 3 heat levels without using the
app by pushing the logo with an auger, which is placed directly under the ON/OFF button on the display.
•
Step 3 (100 % operation): 'ON button' lights green constantly.
•
Step 2 (50 % operation): 'ON button' flashes quickly.
•
Step 1 (10 % operation): 'ON button' flashes slowly.
When you want to switch of the pellet burner, push the ON/OFF button or use the app.
The pellet function can burn up to 24 hours on a full pellet container at level 1, 12 hours at level 2, and 8
hours at level 3. The stove is capable of running day and night, if pellets are added in time.
3.3.5 Lighting the fire with wood and pellets at the same time
Cold stove
Put dry wood in the combustion chamber - just as if you wanted to start the stove manually (see section
3.3.1). However, you won't need any firelighters. The fire is lid with pellets. It will be an advantage, if you
start with a closed air inlet until the fire is burning in the pellet burner. After this, you can open the air inlet for
easier lighting of the firewood. When the logs have caught fire and the smoke temperature is about 275
degrees, the pellet supply will stop automatically.
The stove in pellet operation
When the stove is in pellet operation, you can always add firewood – you just have to remember to close the
door within 3 minutes. Open the door carefully and the pellet supply will stop and the ALARM flashes red.
Add firewood of the correct quality and respect the MAX load line. Close the door again. The stove will now
continue combustion of pellets. When the logs are burning and the smoke temperature is about 275 degrees,
the pellet supply stops automatically. After this, the stove will change to WOOD BURNING mode.
It may occur that the temperature rises above 300 degrees when using pellet operation on heat level 3. If this
happens, the pellet supply stops automatically and the stove will shift to wood burning mode. To avoid this,
reduce the amount of pellets at heat level 3. This is done in the service menu by choosing "auger".
If you use the function "Heat Level" on the app and want the stove to restart automatically
on pellets when the wood has burned out, you can set the Aduro Hybrid on standby mode
with just 1 click on the button (see illustration). The stove will now be in standby mode and
await a smoke temperature below 100 degrees before it starts the pellet combustion and
ignites again. However, if you use the function "Desired Room Temperature", the Hybrid will
start automatically again when the smoke temperature is below 100 degrees.
61