Electrical Connection - ADURO H2 Mode D'emploi

Masquer les pouces Voir aussi pour H2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 70
too weak. If this is the case, we recommend you to buy a new router with a strong signal and a Wi-Fi
amplifier that is located somewhere between the router and the stove.
If other electronic devices work well in the house, but the hybrid stove can't be connected, it is due to the fact
that the hybrid stove requires a stronger Wi-Fi signal than other electronic devices.
At our website you can find more information on how to configurate the Wi-Fi.
Go to
"Wi-Fi connection".

2.6 Electrical connection

Aduro H2 comes with approx. 1.5 meter of cord with an Euro-plug, that should be connected to a 230V /
50Hz outlet. Power consumption during operation is approx. 33 watts. The cord must be positioned so it is
not in contact with hot surfaces or pointed objects.
You can light the fire using just pellets or light it manually with wood – or a combination where you put
firewood in the combustion chamber and use the pellets to light the fire.
Important safety information
The Aduro H2 will become warm during use and therefore it should be treated with all necessary
caution.
Never keep easily combustible fluids such as petrol in the near of the Aduro H2.
Never use easily combustible fluids to light the fire in the Aduro H2.
Never empty the ash pan when the Aduro H2 is warm. Embers may still be found in the ash pan
for up to 24 hours after the fire has gone out. Please wait to empty the ash pan until you are sure
that there are no embers in the ash.
The door should be kept closed while the Aduro H2 is in use. While lighting the fire, the door can
stand ajar for the first few minutes.
The pellet function stops if the door is opened.
When putting logs in a hot stove, you must always open the primary air intake and make sure that
the wood ignites within 2-3 minutes. If the wood does not ignite, add some ignition products and
ignite them manually.
In the event of a chimney fire: Close all the dampers on the Aduro H2 and call the fire-fighting
service.
www.adurofire.com/aduro-hybrid
3. Lighting a fire in the Aduro H2
under "Frequently asked questions" and
56

Publicité

Table des Matières
loading

Produits Connexes pour ADURO H2

Ce manuel est également adapté pour:

En13240En14785Ns3058H1

Table des Matières