Preparation - Beko FSE1074 CHN Manuel D'utilisation

4

Preparation

For a freestanding appliance;
'this refrigerating appliance is not
intended to be used as a built-in
appliance.
Your cooler/freezer should be
installed at least 30 cm away from
heat sources such as hobs, ovens,
central heater and stoves and at
least 5 cm away from electrical
ovens and should not be located
under direct sunlight.
The ambient temperature of the
room where you install your cooler/
freezer should at least be 10°C.
Operating your cooler/freezer
under cooler conditions is not
recommended with regard to its
efficiency.
Please make sure that the interior
of your cooler/freezer is cleaned
thoroughly.
If two cooler/freezers are to be
installed side by side, there should
be at least 2 cm distance between
them.
When you operate your cooler/
freezer for the first time, please
observe the following instructions
during the initial six hours.
The door should not be opened
frequently.
It must be operated empty without
any food in it.
Do not unplug your cooler/freezer.
If a power failure occurs out of your
control, please see the warnings in
the "Recommended solutions for
the problems" section.
Original packaging and foam
materials should be kept for future
transportations or moving.
Due to temperature change as
a result of opening/closing the
product door during operation,
condensation on the door/body
shelves and the glass containers is
normal.
Since hot and humid air will not
directly penetrate into your product
when the doors are not opened,
your product will optimize itself in
conditions sufficient to protect your
food. Functions and components
such as compressor, fan, heater,
defrost, lighting, display and so on
will operate according to the needs
to consume minimum energy under
these circumstances.
16
EN