Using The Unit's 12 V Car Outlet; Replacing The Work Light Bulb - Cartrend 7740013 Mode D'emploi

4.5 Using the unit´s 12 V car outlet 4.4.2 Charging by 12 V car charger
The 12 V car outlet
side of the unit may be used as a 12 V
power source for suitable external de-
vices. The socket is always operational.
The load may be a maximum of 10 A.
▪ Be sure the external device is suitable
for operation with a 12 V power
source with a maximum load of 10 A.
Also refer to the manual for the ex-
ternal device!
▪ Verify the external device is switched
off.
▪ Remove the cover
car outlet 21 .
▪ Insert the external device's 12 V car
plug into the unit's 12 V car outlet
(see Image 7).
▪ Switch on the external device.
▪ The operating time of the external
device depends on its power con-
sumption and the charge of the
storage battery.
▪ After using the external device unplug
the 12 V car adapter from the unit's
12 V car outlet.
▪ Then insert the cover
into the opening of the 12 V car outlet
.
21
34
740013_PowerStation_Manual _25_09_2012_booklet_print
Dienstag, 25. September 2012 17:17:38
21 located on the
20 from the 12 V
21
all the way
20
Image 7

4.6 Replacing the work light bulb

4.4.2 Charging by 12 V car charger
▪ Push the housing frame near where it
connects to the housing (see arrow
Image 8) toward the bulb and remove
the connector.
▪ Then remove the frame and the clear
work light lens , unscrew the bulb
8
(12 V, 3.6 Watt) and replace with a
new bulb.
▪ Replace the clear lens and reconnect
the work light frame with the unit
housing so it locks into place.
Image 8
WARNING! The lens and the
light bulb on the built-in work
light could heat to approx.
°
60 C during and after operation,
possibly resulting in minor burns when
touched with delicate areas of the skin!
DE
Power Station