Cartrend 7740013 Mode D'emploi page 32

Inflating sporting goods, toys and
recreational products
Do not operate the compressor for
more than 10 minutes, then allow the
unit to cool down for 20 minutes!
▪ First read the manufacturer´s instruc-
tions pertaining to inflating and the
maximum pressure before inflating
the item.
▪ Open the valve cap on the product.
▪ Attach the correct valve adapter
using the valve quick disconnect
and insert into the product's valve. If
the valve adapter detaches from the
valve whilst inflating, use your hand to
press it into the valve whilst inflating.
▪ Verify the valve adapter is securely
connected to the product valve by
carefully pulling on it.
▪ Switch the compressor Off / On
switch 16 to ( I ) to engage the
compressor. NOTE: the compressor
can be switched off at any time by
setting the compressor switch
to ( O ).
▪ Observe and check the firmness of
the item whilst inflating. If the item is
already overinflated, immediately
interrupt the process and switch the
compressor off! ATTENTION! Excess
air pressure may cause the product to
burst! Risk of physical injury and
property damage!
▪ Remove the valve adapter from the
product valve and close the product's
valve cap.
32
740013_PowerStation_Manual _25_09_2012_booklet_print
Dienstag, 25. September 2012 17:17:38
Non-binding pressure guidelines
Automotive tyre approx. 1.9 – 3.5 bar
Trailer tyre
Motorcycle tyre approx. 1.7 - 2.9 bar
Bicycle tyre
Football
Volleyball
ATTENTION! Please note the manu-
facturer´s specifications for the item.
Do not use the compressor to inflate
swimming aids!
17
16
approx. 2.4 - 3.4 bar
approx. 2.0 - 4.0 bar
approx. 0.6 - 1.1 bar
approx. 0.18 - 0.22 bar
Power Station