Cartrend 7740013 Mode D'emploi page 26

2.2.14 Incorrect installation of the valve
adapter or incorrectly attaching or
inserting the valve adapters on / in the
item to be inflated may result in an
untight connection between the unit
and product. The leaking air will result
in a pressure drop and subsequently
incorrect air pressure readings.
2.2.15 Keep children and other
individuals away from the unit during
operation.
2.2.16 Do not use the equipment when
fatigued, or under the influence of
medications, drugs or alcohol.
2.2.17 Before switching valve adapters
power the unit off using the
compressor Off / On switch.
2.2.18 Do not aim the compressed air
stream at individuals, animals, dust,
dirt, chemicals, acids, gasses, objects
of any type, or yourself. ATTENTION!
Risk of personal injury and property
damage!
2.2.19 If dusty, clean the area around
the valve before inflating. Wear a dust
mask to protect your respiratory
system. ATTENTION! Risk of personal
injury and property damage!
2.2.20 To prevent malfunctions or the
product being inflated bursting, check
the air pressure with a suitable external
pressure gauge whilst inflating. The
unit's manometer is not calibrated,
thus the values shown should only be
considered air pressure guidelines. The
manometer does not indicate a
binding, accurate air pressure.
ATTENTION! Risk of personal injury
and property damage!
26
740013_PowerStation_Manual _25_09_2012_booklet_print
Dienstag, 25. September 2012 17:17:37
2.2.21 Especially after inflating tyres on
vehicles, motorcycles and trailers
check the air pressure with a suitable
external pressure gauge. Even mildly
incorrect air pressures can impact the
driving characteristics. ATTENTION!
Risk of personal injury and property
damage!
2.2.22 Always follow the pressure
specifications of the item to be inflated
and the manufacturer´s instructions!
2.2.23 Do not use the equipment with
the 230 V charger connected.
2.2.24 Do not expose the unit to
temperature above 60 °C.
2.2.25 Do not overload the unit.
2.2.26 Only carry the unit by the handle.
Keep the handle free of oils, greases
and moisture.
2.2.27 Immediately shut the unit off
after a maximum of 10 minutes of
operation or in the event of overheating
by setting the power switch to ( O ).
Allow the unit to cool down for at least
20 minutes until the regular operating
temperature has been reached and the
unit is again ready for use.
2.2.28 Do not use the compressed air
generated for commercial purposes or
for food-, pharmaceutical-, diving- or
medical purposes.
2.2.29 WARNING! The front
glass of the built-in working
light can heat to approx. 60 C
during operation, resulting in minor
burns when touched!
2.2.30 WARNING - explosive
substances and objects! Do
not inflate swimming aids,
personal protective equipment or
inflatable boats.
°
Power Station