Safety Instructions For Equipment Use - Cartrend 7740013 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
2.2 Safety instructions for
equipment use
2.2.1 Secure the vehicle from rolling
away before adding air or checking the
air pressure on vehicle tyres or jump
starting. ATTENTION - Risk of injury
and property damage! Always engage
handbrake and put the vehicle in gear!
On automatic transmissions set the
vehicle to "Park" and engage the hand-
brake!
2.2.2 Do not operate or start the vehicle
whilst adding air or checking the air
pressure!
2.2.3 Follow safety instructions when
the car is jacked up or on a car lift or
similar!
2.2.4 CAUTION! Risk of elec-
trical voltage near ignition
coils, distributor cap, ignition
wires, spark plugs and electrical com-
ponents inside the vehicle!
2.2.5 Follow the safety instructions and
the manual of the automaker!
2.2.6 Only use the unit in a safe environ-
ment! Keep clothing, body jewellery
and hair away from the unit's air vents.
2.2.7 When using the unit, be sure the
air hose and cables will not be kinked
or damaged by sharp objects or heat
sources.
GB
740013_PowerStation_Manual _25_09_2012_booklet_print
Dienstag, 25. September 2012 17:17:37
Place the cables and compressed air
hose so as not to create a tripping
hazard. Immediately replace a
damaged air hose and cables!
2.2.8 RISK OF SHORT CIRCUIT! When
using the 12 V car outlet on the unit
verify the correct polarity of the item
being connected. Please refer to the
instructions in the operating instruc-
tions and the wiring diagrams for the
connected load. Never connect the two
battery clamps on the unit!
2.2.9 When using the 12 V car outlet on
the unit be sure this will not impact the
safety and functionality of other
systems and devices! Please refer to
the instructions inside the operating
instructions of the connected load.
2.2.10 In the event of malfunctions or
damage immediately shut off the unit
and disconnect from the 230 V charger
or the 12 V car outlet inside the vehicle!
2.2.11 Verify the ignition and all loads
inside the vehicle are switched off
before connecting the unit to the 12 V
car outlet or connecting the two
charging clamps for jump starting!
2.2.12 Improper use of the equipment
may damage electronic vehicle
components. This may result in an
accident or fire. ATTENTION! Risk of
property damage or personal injury!
2.2.13 If you are unsure about the
vehicle function and operation please
consult a qualified professional.
25

Publicité

Table des Matières
loading

Table des Matières