Maintenance Notes - Rehau A-LIGHT2 KOMBI Mode D'emploi

MAINTENANCE NOTES

Regular inspection:
Risk of injury!
Always remove the battery or unplug from the mains before cleaning
and inspection
- Always keep jaw sets, expanding tools and cylinders clean When
soiled, clean them with a brush and oil them Then store the tool in a
dry place
- Before every use, check the jaw sets, expanding tools and the A-
light2 basic tool for damage or visible wear Damaged tools must not
be used anymore and should immediately be sent to an authorised
service center for repair
- Make sure that the jaw sets are fully applied across the whole surface
and at a right angle during the compression process, and the com-
pression sleeve is inserted up to the fitting collar
- Regularly grease the expanding tool tapers Do not apply grease to
the surface of expander segments! Should excess grease reach the
expander segments, the segments must be thoroughly cleaned (e g
cleaning solvent) and then dried
32
Repairs:
Risk of accident!
Do not perform any repairs on the tool yourself! Repairs should only be
carried out by an authorised service center
Storage:
Never store the tool if wet! Dry the tool and grease it Then store it in a
dry place
As a matter of principle, store the tool in its final position (extended
cylinder or jaw sets) to extend its service life
Transport:
Generally transport and store the tool with fitted expander head (risk of
injury, contamination etc)