Tool Preparation; Charging The Battery - Rehau A-LIGHT2 KOMBI Mode D'emploi

TOOL PREPARATION

Charging the battery

Caution! Risk of injury!
Improper handling of the tool may result in personal injury and/or
material damage
- To charge the battery, only use one-phase alternating current at the voltage
indicated on the power rating label
- Charge the battery only by using the charger provided. Using a different
battery or different charger may cause an explosion
- Never operate the charger in an environment presenting the risk of fire or
explosion
- Do not expose the charger to rain or snow
- After charging or before any cleaning, disconnect the charger from the
power source
- Make sure that the battery contacts cannot be shorted by metal objects,
such as screws, instruments, nails etc. (for example, by carrying them in the
pockets of your pants or the like)
Description of the LED display on the charger
Green LED flashes
Red LED flashes
Red LED displays a steady light
Green and red LEDs display a steady light
Green LED displays a steady light
Red and green LED flash alternately
Yellow LED displays a steady light
Yellow LED flashes
Only charge the battery at a room temperature of 10 °C to 40 °C. If you want
to charge a hot or too cold battery, the red LED may flash. A battery which is
too hot can remain in the charger, charging will begin when the battery has
cooled down. A battery which is too cold, however, should be removed from
the charger. Wait until the battery has reached room temperature. Charging
will begin after the battery has warmed up or cooled down.
To charge the battery, connect the charger to the electric power mains and
push the battery securely into the charger. Charging takes about 22 minutes.
The battery charge level is indicated by the LEDs on the charger.
Charger ready for use
Charging delayed, battery cooling
Battery charging, charged level less than 80 %
Battery charging, charged level 80-100 %
Battery is full, charger automatically switches to trickle charge.
The battery can stay in the charger for approx. 24 hours without being damaged.
Depending on the setting, a melody will sound once when the battery is full.
A malfunction exists. The battery cannot be charged. The contacts of the charger or of the
battery may be dirty or the battery is worn out or damaged. Clean contacts.
Conditioning charge of the battery to prevent the battery from wearing out quickly. This can occur
when the battery is inserted into the charger at high or low temperatures or when it is completely
charged or completely empty.
Cooling fan malfunction. The battery can still be charged. Clean vents. If malfunction occurs
often, send the charger in for maintenance or repair.
23