Initial Use; Care And Storage; Disposal; Technical Specifications - Beurer BS 99 Mode D'emploi

6. Initial use

The BS 99 mirror can either be operated by battery or by mains operation using the mains plug included in
delivery.
Power supply unit
• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power. The device must be switched off at this time.
• Route the cable safely so that there is no risk of anyone tripping over it.
Inserting the batteries
In order to use the cosmetics mirror, you first need to insert the supplied batteries. To insert the batteries, follow
the steps below:
1. Remove the battery compartment lid on the rear of the device.
2. Insert the three supplied 1.5V AA (alkaline type LR6) batteries. Make sure
that the batteries are inserted with the correct polarity, according to the la-
bel. Do not use rechargeable batteries.
3. Close the battery compartment lid carefully.
Operation
• The light can be switched on or off using the on/off switch located on the rear of the mirror.
• The light intensity can be adjusted by pressing the on/off switch again. There are three light intensity levels to
choose from.
The light switches off automatically after 10 minutes.

7. Care and storage

WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device or
accessories.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or hard brushes.
First unplug the device and allow it to cool off. Then you can clean it with a soft, slightly moistened cloth.
Then wipe it dry with a soft, lint-free cloth.

8. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful
life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accord-
ance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.
The empty, completely flat batteries must be disposed of through specially designated collection
boxes, recycling points or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.

9. Technical specifications

Model:
Supply voltage:
BS 99
Supply:
Input: 100-240 VAC, 50/60 Hz, 0.5 A MAX
Output: 4.5 V DC, 1.5 A, 6.75 W
4.5 V DC (3 x AA batteries)
13
2
1