Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine
Nail holder
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Slide in vertical direction possible.
Lift or lower the nail holder to accept different
length nails.
3 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 90
degrees clockwise until you hear "click".
Magazine
2
3
(3) Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Magazine
Nail holder
First nail
Wire collated nails
Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
Fit the nail head in the guide slot.
Magazine
cover
3
1
/
4
1
2 2
/
4
3
1
2
/
2
/
3
8
2
1
Nail holder
Magazine cover
Nails
— 13 —
First nail
Pawl 1
Driving hole
Plastic sheet collated nails
Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
Fit the nail head and upper side of the plastic sheet in
the guide slot.
Fit the lower side of the plastic sheet in the guide slot
for plastic sheets.
Guide slot
First nail
Pawl 1
Driving hole
(4) Close the magazine cover first and swing the nail
guide closed.
(5) Lock the knob correctly.
Knob
Nail guide
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
English
Guide slot
Pawl 2
Guide slot for plastic sheet
Pawl 2
Magazine cover
Publicité
Table des Matières
