Removing The Packaging From Built-In Combination Ovens; Installation Requirements; Appliance Weight; Location Requirements - Bosch HBL5754UC Instructions D'installation

en-us Installation requirements
Leave the appliance on the packaging base until you lift
7.
it into the cabinet cutout or onto the lower oven.
3.2 Removing the packaging from built-in
combination ovens
Cut the box straps.
1.
Remove the angle boards/ strap protectors from the top
2.
of the carton.
Remove the outer carton by lifting it up and off of the
3.
unit.
You can also cut carefully along the cut line on the back
left side of the carton with a blade shorter than
3/4" (20mm).
Remove the upper boxed unit of the combination oven.
4.
Place it on the floor so that both shipping cartons can
be opened.
Remove the packaging of the individual units per the in-
5.
structions printed on the individual cartons or referring
to
→ "Removing the packaging from built-in single and
double ovens", Page 5
4 Installation requirements

Installation requirements

Read these instructions to prepare the installation space
Installation requirements
for your appliance.
4.1 Appliance weight
The cabinet base must support the weight of your oven as
stated in this table.
Oven type
27" Single ovens
27" Double ovens
30" Single ovens
30" Double ovens
30" Combination ovens
4.2 Location requirements
Ensure your installation location fulfills the following re-
quirements before you begin with the installation proce-
dure.
¡ When an oven is installed at the end of a cabinet run,
adjacent to a perpendicular wall or a cabinet door, allow
at least 1/4" (6.4 mm) space between the side of the
oven and the wall or door.
¡ For oven support, install 2x4s extending front to back
flush with the bottom and the sides of the opening.
¡ The supporting base must be well secured to the floor
or cabinet and must be level.
¡ The cabinet opening must be plumb and the base must
be flat and level.
¡ When installing a side hinge oven, leave at least
10" (254 mm) clearance to allow the door to open.
¡ Junction boxes can be located anywhere within reach of
the oven's power cable.
6
Weight
145 lbs
(66 kg)
258 lbs
(117 kg)
161 lbs
(73 kg)
292 lbs
(133 kg)
274 lbs
(125 kg)
¡ The cabinet base must be flat and capable of support-
ing the weight of your unit. Refer to the appliance
weight table for the requirements of your oven.
¡ Under-oven dimensions are provided as a general
guideline and may be adjusted as needed based on a
particular application. Consult a design professional for
optimizing personal preferences.
5 30" Single oven dimensions

30" Single oven dimensions

Read here for appliance and cabinet dimensions for
30" Single oven dimensions
30" single ovens.
5.1 30" Single oven appliance dimensions
Allow ¾" (19 mm) gap to nearest cabinet front for door
swing.