Removing And Fitting The Appliance Door; Removing And Inserting The Hook-In Racks - Bosch HBE5451UC Manuel D'utilisation Et D'entretien

Removing and fitting the appliance door

In case of especially heavy soiling, the oven door can be
removed for better cleaning. Normally, however, this is
not necessary.
CAUTION
9
WHEN REMOVING THE OVEN DOOR:
Make sure oven is cool and power to the oven
▯
has been turned off before removing the door.
Failure to do so could result in electrical shock or
burns.
The oven door is heavy and parts of it are fragile.
▯
Use both hands to remove the oven door. The
door front includes glass components. Handle
carefully to avoid breakage.
Grasp only the sides of the oven door. Do not
▯
grasp the handle as it may swing in your hand
and cause damage or injury.
Failure to grasp the oven door firmly and properly
▯
could result in personal injury or product damage.
To avoid injury from hinge bracket snapping
▯
closed, be sure that both locking levers are
securely in place before removing the door. Also,
do not force the oven door open or closed - the
hinge could be damaged and injury could result.
Do not lay the removed door on sharp or pointed
▯
objects as this could break the glass. Lay the
door on a flat, smooth surface, positioned so that
the door cannot fall over.
Removing the appliance door
Open the oven door fully.
1.
Lock both hinges on the left and right using a locking
2.
pin (a).
Note: The locking pins must be fully inserted into the
holes in the hinges.
Grip the oven door on either side with both hands and
3.
close the oven door by approx. 30° (b).
Raise the oven door slightly and pull it out.
4.
Note: Do not fully close the oven door. The hinges
could become bent and the enamel could be
damaged.
Fitting the appliance door
Grip the oven door on either side with both hands.
1.
14
Slide the hinges into the slots in the oven (a).
2.
Note: The notch below the hinges must engage into
the frame of the oven (b).
Lower the door downwards.
3.
Remove the locking pins.
4.
WARNING
9
RISK OF INJURY
Do not touch the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call
customer service.

Removing and inserting the hook-in racks

You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
Grip the front of the hook-in rack and pull it to the
1.
middle of the cooking compartment.
The front hook of the hook-in rack will release from the
hole.
Fold out the hook-in rack further and pull it from the
2.
rear holes of the side panel.
Hold the catalytic cooking compartment panel in
3.
place.
Remove the hook-in rack from the cooking
4.
compartment.
Inserting the hook-in rack
Hold the catalytic cooking compartment panel in
1.
place.
Insert the hooks of the hook-in rack into the rear holes
2.
in the side panel.
Press the front hook of the hook-in rack into the hole.
3.