Removing And Fitting The Appliance Door; Cleaning The Hook-In Racks - Bosch HBL6EI231 Notice D'utilisation Et De Montage

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. When removing the oven door, ensure that the locking
pins are fully inserted into the holes in the hinges.
Open the oven door completely. Lock both hinges on the left
1.
and right using a locking pin. Ensure that the locking pins are
fully inserted into the holes in the hinges.
Grip the oven door on either side with both hands. Close the
2.
oven door to around 30°, gently lift the oven door and pull it
out. Ensure that you do not fully close the oven door. The
hinges may become bent which may cause damage to the
enamel.

Fitting the appliance door
Grip the oven door on either side with both hands. Slide the
1.
hinges into the slots in the oven. When attaching the oven
door, make sure that the notch on the bottom of the hinges
engages in the oven frame. A
$
Lower the door downwards.
2.
Remove both locking pins on the left and right from the
3.
hinges.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call the after­sales
service.
10


Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.
The hook-in racks in each case are fixed to the side walls of the
cooking compartment at three points.
Removing the hook-in racks
Pull the hook-in rack to the middle of the cooking
1.
compartment.
The front hook of the rack will release from the hole A.
Pull the hook-in rack forwards out of the rear holes in the side
2.
panel B.
Hold the catalytic cooking compartment panel securely and
3.
pull the hook-in rack out of the holes.
Cleaning the hook-in racks
Clean the hook-in racks with washing-up liquid and a sponge or
brush.
Inserting the hook-in rack
Insert the hook-in rack into the holes in the catalytic cooking
1.
compartment panel.
Hold the catalytic cooking compartment panel securely and
2.
insert the hooks for the hook-in rack into the rear holes in the
side panel B.
Press the front hook of the hook-in rack into the hole A.
3.