Applications; Prior To Operation - DeWalt D26411 Traduction De La Notice D'instructions Originale

EN GLI SH
D26414
• Press and release the LCD air temperature
indicator and adjuster (d) to set the desired
temperature in 10˚ C increments.
• To continously increase or decrease the
temperature press and hold the LCD air
temperature indicator and adjuster (d).
• Release the indicator when desired temperature
or minimum/maximum temperature is reached.
• The display shows the actual rising/falling
temperature until the desired temperature is
reached.
SET AND FORGET TEMPERATURE CONTROL SYSTEM
D26414
The desired temperature is stored in the memory
of the tool. Each time the heat gun is turned on,
the heat gun heats to the last temperature setting,
with respect to air flow. If unsure about the setting,
always start with a low temperature setting and
gradually increase the temperature until the desired
setting is reached.

Applications

The table below suggests settings for different
applications.
Setting Applications
Low • Drying paint and varnish
• Removing stickers
• Waxing and dewaxing
• Drying wet timber prior to filling
• Shrinking PVC wrapping and
insulation tubes
• Thawing frozen pipes
Medium • Welding plastics
• Bending plastic pipes and
sheets
• Loosening rusted or tightly
fastened nuts and bolts
High • Removing paint and lacquer
• Soldering plumbing joints
• Removing linoleum or vinyl floor
tiles
To Attach the Correct Accessory
This tool is supplied with a set of accessories for
different applications.
30
Icon Description
Cone nozzle
50 mm Fish
tail surface
nozzle
1. Make sure the on/off switch (a) is in position O
and the tool is disconnected from the power
source. Ensure the nozzle has cooled down.
2. Place the desired accessory onto the nozzle.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: Make sure the nozzle
ALWAYS points away from you and any
bystanders.
WARNING: DO NOT drop anything into
the nozzle.
Proper Hand Position (fi g. 2, 3)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
WARNING: Do not place your other
hand over the air vents (Fig. 3).
Proper hand position requires one hand holding the
tool as shown in Figure 2.

Prior to operation

1. Attach the correct accessory recommended for
the application.
2. Turn the air temperature adjustment knob (d ) to
desired air temperature.
Purpose
Shrink sleeving (heat
over concentrated
small area)
Drying, removing
paint, removing vinyl
or linoleum, thawing
(heat spread over
wide area)