Eu Declaration Of Conformity - Festool DSC-AG 125 FH Mode D'emploi

DSC-AG 125 FH
GB
can only be stored in an enclosed, dry room,
where the temperature does not fall below +5 °C
and where no strong temperature fluctuations
may occur.
– To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
– The machine automatically shuts down if the car-
bon brushes are worn. The machine must be sent
to the bodyshop for maintenance.
– If the pendulum hood [1-5] does not automati-
cally return to the starting position, clean the
pendulum hood by repeated opening and closing.
If the fault cannot be eliminated, hand over the
machine to Customer Service.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
12 Environment
Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
22
Information on REACh: www.festool.com/reach
13

EU Declaration of Conformity

Dia cutting system
DCC-AG 125 FH
AG 125-14 DE
Year of CE mark: 2014
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following Directives, standards and normative
documents:
2006/42/EG, 2004/108/EG, 2011/65/EU, EN 60745-
1, EN 60745-2-3, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Johannes Steimel
Head of Research, Development and Technical
Documentation
2014-08-20
Serial no.
10020077
500591