Switch On/Off; Accessories; Service And Maintenance - Festool DSC-AG 125 FH Mode D'emploi

9.1

Switch on/off

Switching on

Move the ON/OFF switch [1-2] forwards.

Continuous operation: Pressing the front part
of the switch at the same time locks the ON/OFF
switch.
The electric power tool starts.
Only make contact with the material once the ma-
chine has reached operating speed.
Switching off

Lift the power tool from the processed material.

Release the ON/OFF switch[1-2].

During continuous operation: Press the rear
part of the ON/OFF switch[1-2].
WARNING
Rebound, ejected parts
Risk of injury

Before setting down the machine, wait until the
rotating tool has come to a complete stop.
9.2 Insulated gripping surfaces
The power tool must be held using two hands at the
insulated gripping surfaces[1-15]: One hand at the
motor housing behind the switch and one hand at
the additional handle[1-4].
If the additional handle is removed for cuts close to
the edge, the left hand must hold the power tool at
the pull-back arm[1-3].
9.3 Cuts close to the edge [5]
WARNING!With the exception of cuts close to
the edge, the extraction hood can only be
used with the locked pendulum hood and the
additional handle.

Remove additional handle.

Check whether the pendulum hood can move
freely with the pull-back arm and automatically
returns to the starting position.

Hold the power tool using the right hand.

Shortly before the wall unlock the pull-back
arm of the extraction hood using the left hand.

Pull back the pendulum hood using the pull-
back arm and, at the same time, continue cut-
ting to get as close to the wall as possible.
The maximum function of the dust extraction is
thus guaranteed.

After the cutting process, bring the pendulum
hood back to the starting position with the pull-
back arm.
9.4 Tabletop
The tabletop [6-1] reduces the risk of surface dam-
age to the workpiece. Push the tabletop to the front
edge of the guide table of the extraction hood and
lock into place.
10

Accessories

WARNING
Risk of injury

Always pull the mains plug out of the socket be-
fore performing work on the machine such as
changing and adjusting accessories!
Always use original Festool tools and accessories.
Using low-quality tools or accessories from other
manufacturers may increase the risk of injury and
cause serious machine imbalance that decreases
the quality of the working results and accelerates
machine wear.
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
11

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Use only original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Regular cleaning of the machine, above all
the adjustment devices and the guides, is an
important safety factor.
– The packed machine can be stored in a dry loca-
tion without heating, if the internal temperature
does not fall below -5 °C. The unpacked machine
DSC-AG 125 FH
GB
21