Machine Features; Dust Extraction; Auxiliary Handle - Festool DSC-AG 125 FH Mode D'emploi

Angle grinders
Power supply
Mains frequency
Power consumption
No-load speed
Circumferential speed
Grinding spindle thread
Weight
Safety class
5

Machine features

[1-1] Angle grinders
[1-2] On/Off switch
[1-3] Pull-back arm
[1-4] Additional handle
[1-5] Pendulum hood
[1-6] Cut indicator
[1-7] Extraction hood
[1-8] Guide table
[1-9] Thread for additional handle
[1-10] Speed control
[1-11] Mains power cable
[1-12] Spindle lock
[1-13] Transmission housing
[1-14] Extractor connector
[1-15] Insulated gripping surfaces (grey shaded
area)
Accessories shown or described are sometimes not
included in the scope of delivery.
The specified illustrations appear at the beginning
of the Operating Instructions.
6 Settings
WARNING
Risk of injury, electric shock

Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
6.1

Auxiliary handle

Always use an additional handle , in order to
guarantee safe and fatigue-free working po-
sition, unless otherwise specified.
With help of the special "VIBRASTOP" feature, the
AG 125-14 DE
vibrations are reduced by the additional handle[1-
220 - 240 V ~ 4].

50/60 Hz
1400 W
6.2
3500 - 11000
rpm
Smooth start-up
80 m/s The electronically controlled smooth start-up pre-
vents kickbacks. A fuse with 16 A is sufficient
M 14
thanks to the restricted start-up current.
2,3 kg
Speed control
/II
You can regulate the speed steplessly within the
speed range using the adjusting wheel [1-10] (see
Technical data). This enables you to optimise the
speed to suit the respective material.Please also
note the specifications on the tools.
Kickback protection
In the event of sudden speed reduction, for example
as a result of a blockage in the cut, the power sup-
ply in the motor is interrupted. Following recom-
missioning, first of all the machine must be
switched off and then switched back on again.
Restart protection
The integral restart protection prevents the ma-
chine from automatically starting up again after an
interruption in power when the machine is used in
continuous operating mode. In this case the ma-
chine must be switched off and then switched back
on again.
Constant speed
The preselected motor speed remains constant
through electronic control to ensure a uniform cut-
ting speed even when under load.
Overload protection dependent on the tempera-
ture
To protect against overheating, the safety electron-
ics switch to cooling mode when a critical tempera-
ture is reached. The motor continues to run and the
constant speed is deactivated. After a cooling time
of approx. 10-20 seconds, the machine can be oper-
ated again at full load.
6.3
Dust hazard

Always work with a dust extractor.

Always observe country-specific regulations.
Screw in additional handle [1-4] at the
thread[1-9].
Electronics

Dust extraction

WARNING
DSC-AG 125 FH
GB
19