WMF KULT X Mode D'emploi page 16

Switching on
▪ Functions of the operating switch (6):
0 - Off
I - Low speed
II - High speed
P - Pulse function: Short pulses at a high speed, as long as the switch is held in the position
▪ Stainless steel blade (7):
The stainless steel blade is extremely versatile. You can use it to chop meat and vegetables, or even
bread and nuts, for example. The processing time depends on the desired consistency. Use the pulse
function P for coarser results.
To chop e.g. biscuit, first break it into small pieces and add it through the insertion opening in the
lid (2) while the motor is running.
▪ Kneading blade (11):
Use the kneading blade to prepare different types of dough (e.g. yeast dough). Add the dry ingre-
dients to the preparation container (4) first of all, and then add the liquid ingredients through the
insertion opening in the lid (2) while the motor is running.
Knead the ingredients (approx. 30 seconds) until an elastic ball of dough has been created.
Note: Continue kneading the dough by hand if necessary. Do not continue using the food proces-
sor, as this could overload the motor.
▪ Strip cutting disc (julienne) (8):
Use the strip cutting disc (julienne) to cut vegetables into strips and to prepare French fries from
potatoes.
Add the required vegetables through the insertion opening in the lid (2). Only switch the appliance
on once you have done this.
Slowly and evenly push the vegetables downwards with the stopper (1).
▪ Fine and coarse cutting / grating disc (9 and 10):
Use the cutting / grating discs to slice or finely and coarsely grate vegetables. The required tool
must be pointing upwards when inserted.
Add the required vegetables through the insertion opening in the lid (2). Only switch the appliance
on once you have done this.
Slowly and evenly push the vegetables downwards with the stopper (1).
Set the operating switch (6) to speed setting I for softer ingredients (e.g. tomatoes, pickles). Use
speed setting II for harder ingredients (e.g. carrots, potatoes).
Finishing work
▪ Once the ingredients have been processed, turn the operating switch (6) to the 0 (off) position and
pull the mains plug out of the socket.
▪ Release the preparation container (4) from the motor (5) by turning it slightly anti-clockwise and
remove.
▪ Release the lid (2) from the preparation container (4) by turning it slightly anti-clockwise and
remove.
▪ Carefully remove the drive shaft (3) with the tool and place aside.
▪ Empty the preparation tank (4) and clean all the parts used.
16