Gas Leaks; Electric Heater - Qlima GH 959 RF Manuel D'utilisation

Masquer les pouces Voir aussi pour GH 959 RF:

Table des Matières

Les langues disponibles

Release the knob and turn it to the position corresponding with the desired amount of heat:

1. To turn OFF the device, close the gas container (follow the instructions provided with the

low-pressure regulator).

2. Do not hold the regulation knob pressed down for longer than 40 seconds.

3. Never move the heater when it is hot and/or in operation.

F. Gas leaks

If you think there may be a gas leak, please follow this procedure:

1. Close the gas container (follow the user instructions for the regulator);

2. Extinguish all open flames, for instance stoves;

3. Open windows in order to increase airflow circulation;

4. Turn off electrical devices, for instance lamps;

5. Prepare a bucket of soapy water;

6. Open the gas container (follow the user instructions for the regulator);

7. Brush the soapy water on all fittings and connections of the gas circuit;

8. If there is a gas leak, bubbles will rise up from the location of the leak;

9. If a leak is found, close the gas container (follow the user instructions for the regulator).

10. Tighten the fitting and the metal rings of the connection;

11. Open the gas container (follow the user instructions for the regulator) and repeat the

procedure again.

If there is still a gas leak contact a professional and qualified engineer for help.

G. Electric Heater

The electric heating system is designed for infrared radiation technology. Even if used in an

unsealed large room the efficiency will be perfect. There is a switch to select Gas or Electric

heating. The heater has two heating elements, which can be used separately or together

depending on the need.

Operation:

a. Make sure that the plug is normally earthed. Put the plug

into the socket.

b. Press switch "Fan" to get ready to use the heater and to start

the fan.

c. Press switch "I" to start electric heating with half effect.

d. Press the other switch "I" to start electric heating with

maximum effect if needed.

e. Turn OFF all switches after use. Remove the plug from the

socket.

Table des Matières