Husqvarna T435 Manuel D'utilisation page 22

Masquer les pouces Voir aussi pour T435:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To adjust the high speed needle (H)
The engine is adjusted at the factory to operate at sea
level. At higher altitudes, in different weather or different
temperatures it can be necessary to adjust the high
speed needle.
Turn the high speed needle to make adjustments.
CAUTION:
speed needle screw across the
adjustment limitation stop. This can
cause damage to the piston and the
cylinder.
To examine if the carburetor is correctly
adjusted
Make sure that the product has the correct
acceleration capacity.
Make sure that the product 4-cycles a little at full
throttle.
Make sure that the saw chain does not rotate at idle
speed.
If the product is not easy to start or has less
acceleration capacity, adjust the low and high speed
needles.
CAUTION:
can cause damage to the engine.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
2. Remove the starter housing.
3. Pull out the starter rope approximately 30 cm/12 in
and put it in the notch on the pulley.
22
Do not turn the high
Incorrect adjustments
x4
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. Remove the bolt in the center of the pulley and
remove the pulley.
6. Remove the used starter rope from the handle and
the pulley.
7. Attach a new starter rope to the pulley. Wind the
starter rope approximately 3 turns around the pulley.
8. Connect the pulley to the recoil spring. The end of
the recoil spring must engage in the pulley.
9. Attach the screw to the center of the pulley.
10. Pull the starter rope through the hole in the starter
housing and the starter rope handle.
11. Make a tight knot at the end of the starter rope.
To tighten the recoil spring
1. Put the starter rope into the notch in the pulley.
2. Turn the starter pulley approximately 2 turns
clockwise.
3. Make sure that you can turn the pulley ½ turn after
the starter rope is fully extended.
733 - 012 - 08.07.2021

Publicité

Table des Matières
loading

Table des Matières