Husqvarna T435 Manuel D'utilisation page 14

To prepare to start with a warm engine
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Push the air purge bulb about 6 times or until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
To start the product on page 14 for
3. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your knee on the rear part of the top handle.
14
The chain brake must be
You must keep your feet in
If the saw chain rotates at
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
cord around your hand.
CAUTION:
rope to full extension and do not let go of
the starter rope handle.
a) If you start your product with a cold engine, pull
the starter rope handle until the engine fires.
Note:
You can identify when the engine fires
through a "puff" sound.
b) Put the choke control in choke position.
5. Pull the starter rope handle until the engine starts.
6. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
7. Move the front hand guard rearward to disengage
the chain brake.
8. Use the product.
Do not twist the starter
Do not pull the starter
733 - 012 - 08.07.2021