Features; Assembly; Operation - Ryobi P325 Manuel D'utilisation

PRODUCT SPECIFICATIONS
Motor ..................................................................18 Volt DC
Magazine Capacity ...............................................100 Nails
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Finish and Trim (Interior and exterior)
 Door & Window Casing
 Door Jambs
 Baseboard
 Crown Molding
 Cabinetry

FEATURES

Nail Type ...............................................................16 gauge
Finish Nail Length ............................................. 3/4 - 2.5 in.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

 Cap and Shoe Molding
 Molding
 Staircases
 Door and Window Trim
 Chair Rail
 Brickmold
 Hardwood Flooring
 Paneling
 Furniture
ATTACH BELT CLIP
See Figure 1, page 13.
The belt clip can be installed on the left or right side of the
nailer, depending on operator preference.
 Align belt clip and screw with right or left side screw hole.
 Using a phillips head screwdriver (not included) tighten
securely.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 13.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
NOTE: Squeeze LED light grip switch to activate nailer.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
8 — English