Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.7 Decommissioning
Store the compressor in a dust-free and dry
area where it is not exposed to high tem-
perature fluctuations.
2.7.1
Environment
Do not dispose of the device in
household waste! Recycle de-
vices, accessories and packaging.
2.8 Troubleshooting
Problem
A Protective
motor
switch
interrupts
power supply
B Pressure relief does
not function
C Compressor
not
start
when
switched on.
D Compressor
starts
up briefly / buzzes
and then switches
off automatically
E Compressor
continuously
Cause
In case of malfunctions (e.g.
overheating;
extension cable too long or
with incorrect cross-section),
the protective motor switch is
tripped.
Power failure / undervoltage in
mains
with
switched on
does
Vessel pressure is higher than
switch-on pressure.
Power supply faulty.
Protective motor switch inter-
rupts power supply.
Pressure switch defective
Mains connection cable longer
than permitted or the cross
section is too small
runs
Intake filter badly contami-
nated
Air consumption of compressed
air tools is too high
Leakage at compressor
Excessive condensate in the
tank
Compressed air line leaky
Condensate drain valve is open
or missing
Observe applicable national regulations.
EU only: In accordance with European Di-
rective on waste electrical and electronic
equipment and implementation in national
law, used electric power tools must be col-
lected separately and handed in for environ-
mentally friendly recycling.
Remedy
Switch off the compressor. Wait a
low
voltage;
short while. Actuate the protec-
tive motor switch is available.
Switch on the compressor.
Protective motor switch trips
again: switch off compressor.
Disconnect the power supply.
Contact the service partner
Switch off the compressor. It de-
compressor
pressurises. Switch on the com-
pressor
Relieve pressure in the vessel
until the pressure switch is acti-
vated automatically.
Have the power supply checked
by a qualified person (service
partner).
See item A.
Have
changed by a qualified person.
Check connection cable length
and
Chap. 2.4.4)
Clean or replace
Check air consumption. Contact
the service partner
Locate leak, contact service part-
ner
Drain
Chap. 2.6.5)
Check the compressed air net-
work, seal leak
Close or replace
UNM / CPM / ZPM / SEM - OF
the
pressure
cable
cross-section
the
condensate
GB
switch
(see
(see
II/9
Publicité
Table des Matières
