Device Connection - Urmet 1080P Série Manuel D'utilisation

4

DEVICE CONNECTION

There are two types of connection：
1. Connect the device with PC
Connect IP camera with PC by network cable. The supply hub of IP camera is connected with DC 12V power supply. Set
the IP address of PC and that of IP camera in the same network segment. If the network is normal, wait for 1 minute after
power on and IP camera will establish communictaion with PC.
2. Connect the device with router or switch.
It the most commonly used way to connect IP camera to the Internet. Connect IP camera and PC to Lan Port on the router
or switch and set the gateway of IP camera as that of the router.
DS1093-176 43