Activex Control Setup - Urmet 1080P Série Manuel D'utilisation

2. If the searched IP address and PC IP address are not in the same network segment, user may modify IP address,
subnet mask, and other parameters of IP camera by using Easy Tool software.
First select the device to modify IP address and then input new IP address, subnet mask, gateway (subnet mask and
gateway can be inherited by PC) and username/password. Click Modify Network to change IP address of the device.
IMPORTANT NOTE
Default IP of IP camera is "192.168.1.168", username is "admin", password is "admin", media port number is "6066" and
command port "6060".
7

ACTIVEX CONTROL SETUP

If the user visits IP camera with Internet Explorer for the first time, he has to install the plug-ins. For installing the plug-ins,
it is necessary to set the browser security level. Enter menu [Tools/Internet Options/Security/Custom Level] and change
"ActiveX controls and plug-ins" as "Enable" or "Prompt", as shown in the following picture. For safety, after you view the
image of IP camera, please reset the security setting in IE browser to default level.
Installation method of plug-in：
Input IP address of IP camera in IE address bar to visit IP camera. The controls will be automatically loaded on IP camera.
：
The plug-in installation dialogue box will be popped up. Click "Install" and the installation will be completed automatically.
DS1093-176 45