Urmet 1080P Série Manuel D'utilisation page 53

The IP CAMERA parameters must be allocated manually. Select "Type = Static" on the "Menu
and fill in the following fields: IP address, subnet mask, gateway and DNS.
Press SAVE to save the changes.
IMPORTANT NOTE:
The DNS fields must be filled in correctly for correct operation of the DDNS system.
Port setup
1.
At this point the external doors of the router must be forwarded to the IP CAMERA. The function is usually called
"Port-forwarding" or "Virtual Server" in the router configuration menu. The ports set on the router must correspond to
those of the IP CAMERA.
Set different values on the IP CAMERA if the default ports of the IP CAMERA (80, 6060,6066) are already in
a)
use in the port-forwarding table of the router.
Set the ports on the IP CAMERA and port-forward of the same ports to the router. There are two different ways
b)
to do this:
Automatic mode: If the UPnP function is supported and enabled on the router, simply enable the
function also on the IP CAMERA on the bottom of the "Remote Settings
Manual mode: if the UPnP function cannot be used, manually set port-forwarding on the port-
forwarding (or virtual server) table of the router.
IMPORTANT NOTE:
The firewall of some routers could block forwarding of the ports set on port-forwarding tables.
Carefully check the firewall settings of your router too.
IMPORTANT NOTE:
A DDNS server can be used. Select from the available options in the list. See the instructions
on the user manual of the device router for more information.
DS1093-176
Network"
Network" page.
53